Item # KD5006R, MAX-HT™ KD Series 500 Horsepower (hp), 1200 Revolutions Per Minute (rpm), and 5810C Frame Three Phase NEMA Premium TEFC Severe Duty Motor On Gainesville Industrial Electric Co.

Unit of Measure

Specifications | Applications | Features | Note

Brands	N/A TECO
Power	N/A 500 hp
Speed	N/A 1200 rpm
Frame Number	N/A 5810C
Full Load Efficiency	N/A 95.0 %
Full Load Power Factor	N/A 76.5 %
Full Load Ampere at 460 Volt (V) Voltage	N/A 130 A
Approximate Shipping Weight	N/A 5,710 lb
Enclosure	N/A Totally Enclosed Fan Cooled (IP55)
Voltage	N/A 2300 V4600 V
Phase	N/A Three
Frequency	N/A 60 Hz
Continuous Service Factor for 60 Hertz (Hz) Frequency	N/A 1.15
Ambient Temperature	N/A 40 ºC
Elevation	N/A 3300 ft
Shaft Material	N/A High Strength 4140 AISI Steel Shaft
Certification	N/A Canadian Standards Association (CSA)

N/A

N/A

CSA Certified for Class I, Div. 2, Groups B, C, D - Temp Code T3 Minimum
CSA Certified for Class II, Div. 2, Groups F & G - Temp Code T3 Minimum
Class F Insulation
Class B Temperature Rise
NEMA Design C Torques; Equal or Greater Than 200% Starting Torque/250% Breakdown Torque
Cast Iron Frame, End Brackets; Pressed Steel Plate Main Conduit Box and Fan Cover
- F# 447T(Z) - 449T(Z) with Cast Iron Main Conduit Box and Cast Iron Fan Cover.
Grounding Terminal Inside Main Conduit Box with additional Foot Grounding Provision
Oversized Main Conduit Box Rotatable in 90 Degree Increments - F1 Mounted
Bi-Directional Rotation
Aluminum Die Cast Squirrel Cage Rotor Construction
Paint System: Phenolic Rust Proof Base Plus Polyurethane Top Coat
Paint Color: Dark Gray - Munsell 7.5 BG 3.5/0.5
High Quality Ball (or Roller) Bearings Regreasable with Mobil Polyrex™ EM
Automatic Grease Discharge Fittings
Metal Flinger on Both Ends
Cast Iron Inner and Outer Bearing Caps
Stainless Steel Nameplate
Suitable for Inverter Duty (PWM - Pulse Width Modulation) per NEMA MG-1

Inverter Duty Speed Range: 10:1 Variable Torque, 3:1 Constant Torque
6 Leads
CSA Approved
Locknut and Washer on NDE for Vertical Shaft Down Applications
Drain Holes/Plugs on Both End Brackets for Vertical Applications
Threaded One Way Breather Drains for Horizontal Mount Applications
100 Ohm Platinum Stator RTD's; in separate Auxiliary Box
Space Heaters; in separate Auxiliary Box (Space Heaters are Low Temperature Type; Suitable for Hazardous Location Division 2 Environments)
Mounting Provisions for Bearing RTD's and Vibration Detectors on F# 5007 and Larger
Spotface 1/4 -28UNF Tap x 12mm Deep on Top of Both End Brackets with VB300 Vibration Sensor on 5000 Frames and Larger

N/A Data subject to change without notice.

Brands