Exit
1011 Athens Street
Gainesville, GA 30501 USA
Gainesville Industrial Electric
Marlow Pumps Standard Construction:
  • Casing - Close Grained Cast Iron
  • Base - Close Grained Cast Iron
  • Impeller - Nickel Plated Cast Iron
  • Diffuser - Nickel Plated Cast Iron
  • Shaft Seal - 5/8" Viton, Stainless and Brass, Self-Lubricating
  • Shaft - Type 416 Stainless Steel
  • Elastomers - Model EVP - Viton
Unit of Measure

Manufacturer

N/A Marlow Pumps

Model Number

N/A 20EVP-10A1

Impeller Type

N/A Closed

Maximum Size Solids Handled

N/A 3/16 in

Applications

N/A Petroleum and Solvents

Horsepower

N/A 1

Phase

N/A 1

N/A

    Pump: Heavy duty cast iron construction, with 2" NPT female threaded, in-line suction and discharge ports. This compact, vertical design is self-supporting and requires a minimum of floor space.

    The self-priming feature allows the pump to be mounted above the liquid and suction lifts of 10' to 20' can be achieved, depending on the liquid and the pump model. Diffuser priming eliminates the need for a check valve and reduces radial loads insuring longer bearing life.

    These pumps are sealed by a self-lubricating, Viton mechanical shaft seal. When used on a suction lift any leakage that may occur will be down into the pump rather than up the motor shaft as the seal is on the suction side of the impeller.

    Motor: Single phase motors are 60 cycle, 115/230 volt, except 2 HP explosion proof motors which are 230 volt only. Three phase motors are 60 cycle. 230/460 volt and all are 3450 RPM motors. All explosion proof motors are Class I, Group D, Code: T3B.

    Optional Mounting: All models fit the Marlow lightweight, two wheel chassis. Kit illustrated in Section 800.

    Optional Seal: Kalrez mechanical seals are available. Contact factory for more information.